I use the tool Ultimaker Cura for printing. The printer Anycubic Vyper provides the standard settings I use for Ultimaker Cura.

For the following filaments I change the settings as follows:

  • Filamentworld Normal: Default print settings work fine
  • Filamentworld Silk: Use 190°C or even 185°C for less stringing. Use Brim Line Count of 16 (instead of 8) for better adhesion or rafts for even more adhesion
    • Green silk: The light green silk worked very well on low temperatures.
    • Violet silk/Copper silk: These had severe problems with adhesion. Increasing the bed temperature to 65°C and the printing temperature to 220°C did the trick. On my next try, I’ll switch to rafts.
  • formfutura easywood (cedar/): 210°C printing temperature
  • Extrudr food-safe: Print at at least 210°C
  • Spectrum glow in the dark blue: Bed Temperature of 45°C. Use Brim Line Count of 16 (instead of 8) for better adhesion. Next time, I’ll try rafts.

General tips for better adhesion:

  • use rafts or increase brim line count. Rafts usually work better.
  • increase printing temperature
  • decrease printing speed

General tips for better print quality:

  • decrease line width from 0.4mm to 0.24mm
  • decrease printing speed